stacting 2013 kymco like 200i

Everything to do with the increasingly popular and nice scooters coming out of Taiwan.
Post Reply
bayrider
n00b
n00b
Posts: 1
Joined: Sun May 07, 2017 1:49 pm
To prevent spam, enter the year 'modern' scooters were first sold in North America (hint: 1982): 1982
Contact:

stacting 2013 kymco like 200i

Post by bayrider »

2013 kymco like 200i, how to start. Does it have to be on center stand to start? New battery, juice, turns over but won't catch. Have side stand up and brake depressed. Suggestions?
User avatar
tiny
Throttle Master
Throttle Master
Posts: 649
Joined: Tue Aug 28, 2012 5:01 pm
To prevent spam, enter the year 'modern' scooters were first sold in North America (hint: 1982): 1982
Location: Mississauga Ontario
Contact:

Re: stacting 2013 kymco like 200i

Post by tiny »

No it does not need to be on the stand to start as I sometimes start my Movie with it off the stand. It cranks but does not turn over check your compression and if you are getting a spark and fuel going to the cylinder.
Good luck mate.
KYMCO ZX50 & Super9, '13 KYMCO Movie 150
kz1000st
Step Thru Star
Step Thru Star
Posts: 189
Joined: Tue Mar 31, 2009 11:58 am
To prevent spam, enter the year 'modern' scooters were first sold in North America (hint: 1982): 1982
Location: NY, USA
Contact:

Re: stacting 2013 kymco like 200i

Post by kz1000st »

Check that kill switch isn't turned to off.
User avatar
Bear 45/70
Scooter Legend
Scooter Legend
Posts: 1672
Joined: Sat Jul 03, 2010 11:31 am
To prevent spam, enter the year 'modern' scooters were first sold in North America (hint: 1982): 1982
Location: Hoodsport, Washington
Contact:

Re: stacting 2013 kymco like 200i

Post by Bear 45/70 »

FYI the Kymco Like 200 does not exist anymore. Kymco dropped it this year because their Like 150i out runs it and they dumped it because it wasn't good enough to go one.
Bear 45/70

'83 Aero 80
'83 Aero 80
'84 Aero 80
'84 Aero 80

'85 Aero 80
'84 Aero 125
'84 Aero 125
'84 Aero 125
'84 Aero 125
'84 Aero 125
'85 Aero 50
'85 Spree
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest